Hello,
I'm attempting to connect a device (syringe pump) to my computer. The device itself is pretty old, so the original cable was lost at some point. I've tried looking for a new cable but with no success. I've also tried to search the web (for ~3 hours) to find an adapter or a schematics of such an adapter, so now I decided to do the adapter myself (with your generous and much appreciated help
. Where do you recommend me to start the design stage? Any thoughts on the matter?
In general, the device address is set to 0 and the baud rate can be-- 300, 1200, 2400, 4800, or 9600.
Attached the pin out of the RJ 9 of the syringe pump and the standard pin out of RS 232.
Thank you,
Simply
I'm attempting to connect a device (syringe pump) to my computer. The device itself is pretty old, so the original cable was lost at some point. I've tried looking for a new cable but with no success. I've also tried to search the web (for ~3 hours) to find an adapter or a schematics of such an adapter, so now I decided to do the adapter myself (with your generous and much appreciated help
In general, the device address is set to 0 and the baud rate can be-- 300, 1200, 2400, 4800, or 9600.
Attached the pin out of the RJ 9 of the syringe pump and the standard pin out of RS 232.
Thank you,
Simply
Attachments
Last edited: