Hi Pommie,
I'm not getting ambiguous results... These two different Encoders simply do not place the gray code values onto the A and B pins when the Encoders are in any of the detent positions... If I move the Encoders and hold them in a position between the detents I can read the correct data... Strange, huh?
My only 'clue' is that the data sheets for both Encoders say they provide "pulsed" gray code outputs... Unfortunately, I need steady state outputs at the detent positions for this project and I haven't found any Encoders at Mouser or Digikey that aren't "pulsed" Encoders...
Thank you very much for taking time to reply... Regards, Mike