Yeah, we Were going to use the spare I/O pins on the Microcontroller and send it wirelessly. They were going to tackle the wireless feed while I had to design a control box. I was going to design a couple PCBs and have them be underneath the main box. We will configure the PIC and the Rx and Tx later, but I need some ideas for the sensors. We are still in the design phase for our next robot, but we need a nicer looking control box.
Thanks
NOTE: The amp rating on the robot can reach up to 100amps with a safety throw of 120Amps. For the Power on indicator, how would I do that? MUST HANDLE 120AMPs.