no that was just fou checing.
I would like a program, that i could use with my webcam. my wecam is on a stepper motor and i would like that it would turn some stepps left and some right(about 45degrees right and 45 left). i want to send commands over the internet somehow, sending command like "cam left 5" (camera turn left 5 steps). it can use mail, msn, etc. stepper is connected to printer ports 4 pins. (don't know the numbers)
the stepper moves fwd by code:
1000
0100
0010
0001
1000
...
and reverse:
0001
0010
0100
1000
0001
...