i just have a question about a stepper motor i have bought .
this motor contan 4 leads and work with 4.6 volts , and MAX 2 A.
my problem is , i need to convert it's leads from 4 lead to 8 lead , can i do it my self . :?
i want do that because of my driver board need the motor to be so .
i just have a question about a stepper motor i have bought .
this motor contan 4 leads and work with 4.6 volts , and MAX 2 A.
my problem is , i need to convert it's leads from 4 lead to 8 lead , can i do it my self . :?
i want do that because of my driver board need the motor to be so .
but i have found a good driver board , abut i can't exactly find where i can wire the motors on this schematic ,so i'll scan it to view it on the computer ....
i hope then you can help and tell me where to connect my motor on this board
Here's a link I supplied for an earlier post in one of the other forums. I think it does a pretty good job in describing what steppers are, how they work, etc. Hope it helps you. https://www.cs.uiowa.edu/~jones/step/
JB