I've got some stepper motors i recovered from old printers, with 5/6 wires coming out (actually 5, because the five wires ones join 2 at the motor and the six wires ones do the exact same thing but on the circuit board).
And i also have two drivers: ULN2023A and ULN2803A.
What i want to do is connect one motor to a power supply so it runs without being controlled or anything, however, i know it can't be done like that, thats why i mentioned the drivers. My question is, how can i connect one motor to a driver so that it will run (as if it was a normal DC motor, on/off)? i don't want to use any microcontroller or port.
Is it possible? if so, which driver would be better to use?
I'd appreciate diagrams for both 2023 and 2803.
And i also have two drivers: ULN2023A and ULN2803A.
What i want to do is connect one motor to a power supply so it runs without being controlled or anything, however, i know it can't be done like that, thats why i mentioned the drivers. My question is, how can i connect one motor to a driver so that it will run (as if it was a normal DC motor, on/off)? i don't want to use any microcontroller or port.
Is it possible? if so, which driver would be better to use?
I'd appreciate diagrams for both 2023 and 2803.