Dr-Chambers
New Member
Allow me to introduce myself.
I was wondering if anyone could kindly display how to connect a 1 transistor per winding as a driver for a unipolar stepper motor to a 1208FS stepper motor drive board.
Also I am planning to use an H-Bridge driver (LM18200T TO220) to drive a bipolar stepper motor.Could you kindly display how to connect this to a stepper motor drive board for a bipolar stepper motor.
[If you think that the LM18200T T0220 is not appropriate as an H-Bridge driver I am open to suggestions.Same goes if you think using mere 1 transistor per winding to drive a unipolar motor].
Thanking you advance.Thank you.
I was wondering if anyone could kindly display how to connect a 1 transistor per winding as a driver for a unipolar stepper motor to a 1208FS stepper motor drive board.
Also I am planning to use an H-Bridge driver (LM18200T TO220) to drive a bipolar stepper motor.Could you kindly display how to connect this to a stepper motor drive board for a bipolar stepper motor.
[If you think that the LM18200T T0220 is not appropriate as an H-Bridge driver I am open to suggestions.Same goes if you think using mere 1 transistor per winding to drive a unipolar motor].
Thanking you advance.Thank you.