Someone Electro said:Stereps wod be beter becose servos are not as precise.
You will need to find out the corordinates on the picture and then translate that in to how many steps has the sevo make.This will probobly requre fine tuning to get it acurate.Also you need an valve of some sort to relese the water.Washing machines have such valves. So if you meaby rewind its coil to make it work at 12V or so,insted of mains.
You cod probobly use the printer port to do it.You just have to conect the transistors to control the stepers and the valve.
Do you have any programing experiance?
hjl4 said:It seems everybody has given up on the "STEPPER", but yet it is the most accurate system around in terms of positioning, cost wise.
Good Luck.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?