Three Phase Transformer

Shadow_warrior

Member

• Jul 15, 2019

• #1

Hello, I want to simulate a 3 phase YD1 (star Delta) transformer in LTSpice, but the output of secondary transformer( Delta SIde is not coming properly). Can please someone check where I am doing wrong?
Attached is the LTSpice file.
Thanks in advance.

 

Attachments

• bcu_voltage_regulation.asc

  2.3 KB · Views: 465

Ramussons

Active Member

• Jul 18, 2019

• #2

Where or what defines the magnetic coupling between the 6 windings? As of now, they are just independent inductors.

 

ronsimpson

Well-Known Member

Most Helpful Member

• Jul 18, 2019

• #3

I think I did something wrong but I am getting power through the transformer.

 

ronsimpson

Well-Known Member

Most Helpful Member

• Jul 18, 2019

• #4

Also I found some startup problems that seem better when you "skip initial operating point solution:"

 

MaxHeadRoom78

Well-Known Member

Most Helpful Member

• Jul 19, 2019

• #5

The basic construction of a three phase transformer is three single phase versions mounted on the same lamination, in fact it is very easy to make one from three identical single phase types.
Max.