I always try to keep my tip clean. So, when I tin wires, for example, quite a lot of solder remains in the tip. I usually clean it with a dump sponge.
If left half a minute, tip starts to get darker, so to avoid this, I melt some solder on it. But sometimes I need to do very accurate soldering, like SMD points, or reapiring tracks, so I can't have much solder on the tip.
Am I doing things right? How could I improve?
Thank you.
If left half a minute, tip starts to get darker, so to avoid this, I melt some solder on it. But sometimes I need to do very accurate soldering, like SMD points, or reapiring tracks, so I can't have much solder on the tip.
Am I doing things right? How could I improve?
Thank you.