Trouble programming flash petterns on a SHO-ME Dual switch

Hi,

I recently installed permanent mount blue LED beacons on my Jeep wrangler, and have dual switch controls for the front and back bumper LED wig-wags, and a dual switch for the 360 beacons. I can manually change the patterns with the green wiring touching the ground, but then that is pattern for the off/on switch. I am having trouble figuring out how to program flash patterns in the switch, and the SHO-ME instructions that came with the switch are useless.

Anyone have any knowledge on this? Thanks

JoeJeep

Do you have a model number for the Sho-Me?

Sho-ME dual switch model #11.1002 and the beacons are Star Halo 255 series.

One other note, possibly the switch isnt friendly with the lights. The beacons said the green wire was for flash patterns, and the white wire was for sync, and if you wanted the lights to alternate, not to use the white wires, but the dual switch is saying the white wire should be used for the pattern changes. A bit confused here. Thanks in advance!