Hi every one,barely back from Christmass?I found a nice way of getting a ckt from the printer to the PCB.Here it is:
Parts:
Transparencies
UHU Glue Stick(your normal one)
Scissors
A4 Printer Paper
Process:
First print your ckt on the transparency,cut out the ckt,cut out an equal piece of A4 paper and stick it on the back side of the transparency(the front side being the ckt side).Put it on your PCB and iron it(I did it for 4-5 minutes).It will stick to the board.Put it in water and scrape it from the sides(Dont try to rip it apart from the center,it will break the tracks).
This way proved better then the TTP i got here(It costs USD3.75).Its not from pulsar.
Any one try it give reviews.
PS:It gets the work done.I only done it once.Will try it aain after holiday since every thing is closed.