Hi,
I have downloaded and installed the "EMC engineer software" from the top of the following web page by Laplace Instruments...
www.laplace.co.uk
However, it wont run as it gives the following error message. ( attached)
"The code execution cannot proceed because usbi2cio.dll was not found. Reinstalling the program may fix this problem"
Do you know how i can solve this so that i can run the software?
Re-installing doesn't help.
.....that driver (usbi2cio.dll) is available on the same download page as linked in the link but when you try and install it, it says it could damage your computer system....so i refrained from installing it. Do you know if its safe? The warning message for usbi2cio.dll is also attached.
I have downloaded and installed the "EMC engineer software" from the top of the following web page by Laplace Instruments...
![www.laplace.co.uk](https://www.laplace.co.uk/wp-content/uploads/2019/10/download-image.png)
Software – Laplace Instruments Ltd
- v4.10 software for SA1002 and SA3000 analysers - Unzip the files and follow instructions in help.doc
![www.laplace.co.uk](https://www.laplace.co.uk/wp-content/uploads/2018/06/logo-noborder80.png)
However, it wont run as it gives the following error message. ( attached)
"The code execution cannot proceed because usbi2cio.dll was not found. Reinstalling the program may fix this problem"
Do you know how i can solve this so that i can run the software?
Re-installing doesn't help.
.....that driver (usbi2cio.dll) is available on the same download page as linked in the link but when you try and install it, it says it could damage your computer system....so i refrained from installing it. Do you know if its safe? The warning message for usbi2cio.dll is also attached.
Attachments
Last edited: