using a circuit board from a project box?

Status
Not open for further replies.
B

Black Blade

New Member
I picked up this small project case at The Source, but the small circuit board that comes with the case has all individual copper dots for each hole...so just wondering how your supposed to use something like that. A stripboard I can see but this...there don't seem to be a way to connect all the parts together.
 
It is the same as using perfboard which has no copper, just a grid of holes. Ben the component leads and add wires as needed.
 
You solder the leads to the copper dots to hold the components on the board. Wiring is done to the leads.
 
So a board like that would not be any good when using an IC then right..you could solder in the IC, but wouldn't want to be reheating the leads of it to attach a wire...board like that seems to be more bother than its worth...just get a better laid out board...one with strips or something...have to see if can get a better board and then make it fit the case.

Edit: Found a tutorial on using perfboard...lol, so maybe I won't toss it yet
 
Last edited:
Black Blade said:
So a board like that would not be any good when using an IC then right..you could solder in the IC, but wouldn't want to be reheating the leads of it to attach a wire...
Click to expand...
Soldering to the lead on the side opposite the IC should be no problem. Just don't use a 50W iron. Use a small iron with a pointed tip.
 
crutschow said:
Soldering to the lead on the side opposite the IC should be no problem. Just don't use a 50W iron. Use a small iron with a pointed tip.
Click to expand...

Agreed. For even more safety (and convenience) you can use an IC socket. I've used this kind of board a quite a few times with no problems (except lifting the pads after reworking too much, but that's a different problem). Now I mostly either do point-to-point wiring or make a PCB though.

Just don't use an IC socket if the thing has to last for years in a high-vibration environment.


Torben
 
Perfboard is awesome if you are any good at soldering. I use it for EVERYTHING. Not a single project has not been perfboard, lol my binary clock (phew)
 
I just picked up number of 'surf boards'
https://www.elexp.com/pro_sbrd.htm

The have pins that will plug into a breadboard so the surfboard is mounted vertical.

I'm using them to build a number of "standard" circuits such as OP-amps, filters, timers etc; that way it cuts down on time to build some circuits(and bread-board space too)
 
Status
Not open for further replies.

Similar threads

  • Question
Project using a Credit Card Payment Terminal as a switch device :))
Replies
15
Views
3K
AnalogKid
  • Question
Ariens circuit board relay fried.
Replies
17
Views
3K
mcostello
F
  • Question
Making a sinusoidal power waveform from two halves?
Replies
9
Views
2K
ZipZapOuch
A Simple Power Supply Project
Replies
1
Views
2K
Tony Stewart
J
  • Question
A circuit to block back-feeding to another line
Replies
15
Views
5K
Nigel Goodwin
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…