Well along with the relay circuit board, it would be nice if the board came with all the standard stuff(Sscrews etc). But the above is what I mainly looking for because I can not find it.
Is the load AC or DC? Stancor manufactures a line of DC coil contactors including 24 volt DC coils for DC loads.
On another note there are SSRs (Solid State Relays) manufactured by a host of manufacturers like Crydom that could likely be used depending on the load current and voltage needed.
Ron
OK, yes those specifications matter very much to someone who cares about selecting the correct part for a job. I suggest you **broken link removed** I am assuming contact voltage of 24 volts and a load of about 60 Amps. Coil voltage is your call. A 60 Amp DC relay is a pretty beefy relay, I assume large lugs to the terminals?