I am having a nightmare with P16PRO40 Programmer. When I try to program a PIC16F84 chip I get a verify error on address 0x00. The software I am using is Picallw the free version from the web.
3-Jan-2004
Gaston Gagnon wrote:
>
> I don't know about Picall, I use Picallw software.
> To program 16f628a do:
> 1) Leave both "Erase before program" and "BlankCh. before prog."
> unchecked
> 2) Hit the Erase button
> 3) Then press Program button
>
> That should do it for you.
>
> Gaston
>
WOW! yes that did it.
Thank you so very much. Do you know if that works for other "A" version
chips?
3-Jan-2004
Gaston Gagnon wrote:
>
> I don't know about Picall, I use Picallw software.
> To program 16f628a do:
> 1) Leave both "Erase before program" and "BlankCh. before prog."
> unchecked
> 2) Hit the Erase button
> 3) Then press Program button
>
> That should do it for you.
>
> Gaston
>
WOW! yes that did it.
Thank you so very much. Do you know if that works for other "A" version
chips?
I have just done that but it still is not working. If I command it to erase the PIC I see one of the Red LEDs Flashing, and the same applies when programming. But it reports an error still.
For the PSU I am using that of an HP Laser jet printer 24v dc. What else could be the problem.