Hello,
I am working on a senior design project right now, and I am working with a circuit which is apparently not working. It is to amplify the output of a load cell and to amplify it from around 30mV to 3V. I am getting an output from the op-amp, but the voltage regulator is not responding properly. I'm new to the voltage regulator -- can someone perhaps take a look at the design and point out any errors in it, if there is? Or what it takes to have it operate correctly?
Thanks,
Andrea
**broken link removed**
I am working on a senior design project right now, and I am working with a circuit which is apparently not working. It is to amplify the output of a load cell and to amplify it from around 30mV to 3V. I am getting an output from the op-amp, but the voltage regulator is not responding properly. I'm new to the voltage regulator -- can someone perhaps take a look at the design and point out any errors in it, if there is? Or what it takes to have it operate correctly?
Thanks,
Andrea
**broken link removed**