Yeh did try Google and then Digikey and found some.
One last question, based on the measurements (using micrometer: 5.70mm x 14.30mm) it shows the resistor to be a 1 Watt and not 2W. The 2W would be to big in length. Is it safe to say that the 1 Watt one is the one. I'll be taking the risk
Yeh did try Google and then Digikey and found some.
One last question, based on the measurements (using micrometer: 5.70mm x 14.30mm) it shows the resistor to be a 1 Watt and not 2W. The 2W would be to big in length. Is it safe to say that the 1 Watt one is the one. I'll be taking the risk
It apparently is a 1W then. I was was just guessing from the estimated size in the picture. So you should be safe to replace it with another 1W.
But do you know what caused it to fail? If you don't then a new one is likely to fail also since those resistors are unlikely to fail unless they are overloaded.