what type of High frequency?

Status
Not open for further replies.
Actually, I understand his question. But without a schematic , there is no specific answer.

ak
 
Miracletech said:
I am testing if the base emitter diode voltage (VBE) decreases with Higher frequency.
Click to expand...
it shouldn't... however Vbe (in silicon) has a negative temperature coefficient of -2.2mV/DegC. transistors lose gain as frequency rises due to capacitances between the junctions, but that doesn't change Vbe.
 
Miracletech said:
Isn't having all in one Better?
Click to expand...
Sometimes. But mostly not.

The fact that they are the same device limits their effectiveness when you need both. I frequently need to look at both a waveform and a voltage at the same time. With an integrated instrument, you need to shift back and forth from one mode to the other.

The times I have used my integrated scope/meter are when I go out into the field to work and I'm limited in what I can carry with me.
 
Do I need a Schematic for a Boost smps? 75% of the electronics world Kind of knows that. I ask questions short and sharp, Schematics or not.
 
Miracletech said:
The reason why I ask a question on a forum is not for "Schematic Purposes". I asked about a "High frequency on a bjt" and said I am designing a boost converter, So, What's wrong?
Click to expand...

The question wasn't to you, it was to AnalogKid who claimed to understand what you were asking - but he's not responded. But your question was meaningless, and a schematic is ALWAYS very important - there are numerous different types of boost SMPS's - and posting the exact schematic would enable people to have a chance of giving meaningful replies to questions that make no sense.
 
Presuming a DC-DC boost converter, this is a PWM output so there will be small changes in bias. doesn't sound unusual, and the cold running just shows the load is very low. Consider the dutycycle here is quite low. You will see this when you can look at it with a scope.
 
A Swiss Army Knife is usually a pretty poor knife. The tooth pick, file and scissors don't work very well either. The spoon is ok but the milk from my cereal gets into the hinge every scoop. The hinge is hard to clean. Dedicated tools are usually much better than multitools.
 
Status
Not open for further replies.

Similar threads

  • Question
What frequency does Victor vc97 multimeter test capacitors?
Replies
5
Views
1K
danadak
N
  • Question
Significance of resistance of the wireless power transmitter coil at resonance frequency
Replies
2
Views
686
danadak
  • Question
What is the waveform and frequency of the lcr t4 device when testing the capacitor?
Replies
7
Views
3K
danadak
  • Question
High frequency voltage measurement with digital multimeter
Replies
15
Views
5K
electronium
J
  • Question
Variable frequency 555 circuit
2
Replies
29
Views
3K
Papabravo
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…