I use Orcad version 10.0 everything seems well but.. I don't know the erroring .. when I complete a board.. and exit from Orcad programe
. that's oke however If i want to adjust this board by unround command and replace some components then I run the auto funtion of round It doesn't allow to auto run again ??? I don't know why ?? unless I have to use the neslist file and arrrange the component then do It's oke !! I send a picture that describle my problem.. I hope You will show me why ?? thanks
. that's oke however If i want to adjust this board by unround command and replace some components then I run the auto funtion of round It doesn't allow to auto run again ??? I don't know why ?? unless I have to use the neslist file and arrrange the component then do It's oke !! I send a picture that describle my problem.. I hope You will show me why ?? thanks
Attachments
Last edited: