Quentin.Lynn
New Member
I have some electronics experience, not a whole lot and have been tasked to figure out a solution. We have a PTZ camera that will go onto a sliding rail systems. We want to use the camera's internal output to drive a servo to move the camera on the slider back and forth. The issue is that the output is only limited to either on or off @ 3 volts DC. My thought is to use some type of 3 stage switch (this is where I am at a loss as to what type of switch) to turn the power "on" "off" and to reverse polarity to reverse the motor. I have not figured out what size motor I will use yet. I'm trying to work through the logic on how it will work before. So in my perfect world, when i press the "on" button, on the camera we slowly start sliding one way. I press "off" we stop. I press "on" again, we go the opposite direction.
Any ideas?
Thanks in advance..
Quentin
Any ideas?
Thanks in advance..
Quentin