I need to work on a project which requires a transmission of a signal consists of 16 bits. The 16 bits need to be transmitted via an RF module (only one RF transmitter and RF receiver). How do I transmit the signal thru the RF module?
I was thinking of using a 16 bit shift registers (parallel in/ serial out) at the beginning before the RF transmitter and also another 16 bit shift registers (serial in/ parallel out) at the receiving end of the RF module. But I find it very hard (extremely hard) to find a 16 bit shift register with serial in/ parallel out chip. I only manage to find a chip which is 74F675A (16 bit shift register with serial in/ parallel out) but it's very rare and most website don't sell them. If they sell, they sell it in large number.
Does this method good enough or is there any other way to perform the transmission?
Is there any other way to transmit the 16 bit signal? I cannot use any PLD or PIC microcontorllers.
I was thinking of using a 16 bit shift registers (parallel in/ serial out) at the beginning before the RF transmitter and also another 16 bit shift registers (serial in/ parallel out) at the receiving end of the RF module. But I find it very hard (extremely hard) to find a 16 bit shift register with serial in/ parallel out chip. I only manage to find a chip which is 74F675A (16 bit shift register with serial in/ parallel out) but it's very rare and most website don't sell them. If they sell, they sell it in large number.
Does this method good enough or is there any other way to perform the transmission?
Is there any other way to transmit the 16 bit signal? I cannot use any PLD or PIC microcontorllers.