Hey there,
My name is Roy. I'm working on my final project these days. It's an wireless ECG. I'm using INA114 op amp but for some reason, when I'm trying to run a simulation with Pspice I'm getting errors all the time. I attached the circuit and the errors.
Can you help me???
:shock:
I use spice, but not Pspice.
If Pspice doesn't rename the nodes inside subcircuits, then you can assume that the errors are on top-level nodes. Pspice should create a viewable netlist. Look at it and see if you can figure out where the errors are.