Hi i need to design a BJT amplifier circuit
and these are the specification i need to follow
The amplifier described in this specification should operate from a single 15-volt supply and have a small signal voltage gain of your choice between 10 dB and 20dB.
The amplifier uses voltage divider bias and has a load resistance of 10k-ohms.
I am thinking to build it on a vero board or a breadboard.
Thanks for your help
Hi i need to design a BJT amplifier circuit
and these are the specification i need to follow
The amplifier described in this specification should operate from a single 15-volt supply and have a small signal voltage gain of your choice between 10 dB and 20dB.
The amplifier uses voltage divider bias and has a load resistance of 10k-ohms.
I am thinking to build it on a vero board or a breadboard.
Thanks for your help
You should give a few more details such as frequency range.There are a number of approaches for that.You may use 1/10 rule which assumes Ve=(1/10)*Vcc.Draw the dc equivalent of voltage divider bias.We have different models for different frequency ranges.You can find them in any of the electronics book.