Circuitmaker2000 question.....

Hello again.I want to make a new Component in circuitmaker2000.Instead of using, say a 4017 device from the list,I would like to make a generic 16 pin dip IC.On the screen it would just show the 16 pin numbers.Now I think I figured this part out,but I can not get the component to load in traxmaker.How do I go about getting this done.Thank you for the help....... :?

Did u try assigning a footprint to ur device when u edited it in Circuit maker, because if it has an associated footprint, it will be exportedt ot Traxmaker.