Thank you both very much for the quick replies,
As for the pulse width (time) I'd be guessing at 500 milliseconds, my objective is to replace a momentary switch.
(The momentary switch In the attached (B/W) image)
The link below has the specs for the solid state relay In the attached (B/W) image.
http://bluesea.com/category/78/79/productline/385
As for the load in the Bluesea Systems specs it states "<7.0 Amps" , but the link from the place I bought it from states
" Amperage Operating Current 100mA when changing state", see link below.
**broken link removed**
Unsure how to answer the "restrictions on the how the outputs of this circuit behave when power is applied",
Other than to say I would like it to consume little to no power when it has 0v (open circuit) on its input.
And would prefer if outputs stay zero volts when power is applied.
Also thanks alec_t for Schematic, at a glance it looks perfect for the job. (will build tomorrow)
Although if you could give your opinions using this extra info, just to make sure I'm on the right track.
Thanks again