technosteve
New Member
I need any ideas on how to take a variable source signal, which is 0-10V use that to be able to vary the resistance from 0 ohms to 5K ohms.
I was thinking of using a digital potentiometer, but not sure how I can integrate that.
Basically, I have an LED driver, which has a current set resistor, and I want to be able to change the output value of that current set "resistor" using the 0-10V input. The output would just be a milliamp or two. Make sense?
I am open to ANY ideas.
Thanks!
Steve
I was thinking of using a digital potentiometer, but not sure how I can integrate that.
Basically, I have an LED driver, which has a current set resistor, and I want to be able to change the output value of that current set "resistor" using the 0-10V input. The output would just be a milliamp or two. Make sense?
I am open to ANY ideas.
Thanks!
Steve