k7elp60 said:
I used to use my 10 inch table saw with a fine carbide tipped blade. Just had to allow for the width of the the blade, 1/8".
I have a shear very similar to the one posted by Phiba. I purchased if from Northern Tool about 2 years ago. I use it all the time and it works very well for me.
That sounds like a good idea. I could then cut it on the Triton.
Do you mean that you used a carbide tipped wood saw blade? Or some other type of blade?
I took a photo of the Triton in the Jigsaw/Router mode but without the Jigsaw or router mounted.
For anyone that is interested & has not seen a Triton, I also took photos of it in some of its other modes.
Photo 2 shows the bench saw mode.
Photo 3 shows the cross cut saw mode, but I oriented the saw incorrectly. It should have been turned 180 degrees.
Photo 4 shows the planer mode.
It has adjustable mounting plates for a variety of comercially available power tools.
There is also an extension table that can be set up for sawing large sheets of chipboard, plywood, etc. but I need the car out of the garage to set it up.
It only takes 2 ~ 3 minutes to change modes.
There is also a vacuum dust extractor available - it uses a standard vacuum cleaner.
EDIT. I've had problems attaching the photos - I'll try again later.