Hi. a quicy:
At what rate caps shoud i use for the caps that are connected triagonally to the motor 2 pins? is it 0.1uF? i just cant remember that anymore.
Thanks a bunch.
Hi. a quicy:
At what rate caps shoud i use for the caps that are connected triagonally to the motor 2 pins? is it 0.1uF? i just cant remember that anymore.
Thanks a bunch.
k i found what i needed. i needed to put some caps to eliminate at least some of the EMF they make. 1 across the leads and 2 from lead to GND (1 for each pin).
100nF betwean the leads and 1-10uF from pin to GND
Sry if my english is too bad. also my keyboard plays tricks on me. it sometimes leave out some letters and adds some that are not reuired. :evil: