If it makes it easier, I can replace the DPDT toggle with a push button. I wanted to use the toggle because it reverses the DC motor and power was always on. Let me try to explain what I am doing. My Dad is a model train fanatic. He has made this large scene downstairs and I wanted to help him make a backdrop. I am using Unistrut and I have already bought the motor, and made the motor enclosure. I mounted this box with some roller bearing above it, so the motor shaft raises up inside the channel, and using a small wheel, mounted to the tip of the shaft to drive the motor carriage one way or the other. My vision on this is to have the motor carriage get so far to one end, hit some sort of stop (toggle opposite), then have a delay of time (variable), then start in the opposite direction till it hits the other end stop. There it will pause on a delay before reversing again. etc. etc. over and over until my dad turns off all the power to the scene. I have no problem going down to the shack and buying some push button switches, just was not sure what to get and I already have a toggle wired up.