MrDEB
Well-Known Member
ALL is not good in DIY land
I drilled out the boards and wanted to start mounting parts--oups!!!
the printer must have made the printout slightly smaller. Never had this problem before??
the pads on the IC's are off slightly. On an 18pin socket its off by one pin over the 9 pin length.
lets see .1 spacing so its off by .01x9??
need to start over and get it right. Using a perf board sucks when running numerious wires in a tight space.
need to recheck print settings or ??
I drilled out the boards and wanted to start mounting parts--oups!!!
the printer must have made the printout slightly smaller. Never had this problem before??
the pads on the IC's are off slightly. On an 18pin socket its off by one pin over the 9 pin length.
lets see .1 spacing so its off by .01x9??
need to start over and get it right. Using a perf board sucks when running numerious wires in a tight space.
need to recheck print settings or ??