Hello everyone. This is my first post. I am looking for some help to complete what I think might be an interesting project.
I need for several uses a cavitation effect washer. Basically an ultrasonic bath, however the level of thoroughness I need in the cleaning process is high therfore I was thinking of using a boat transducer designed to emit a 200khz wave. It was desgined to be mounted on hulls and connected to imaging devices (ecosonar)
I do not need a precise control nor that the unit is powered to full potential however is there any way to pilot this device at its designed frequency? 200khz is all I know and that the piezoelectric unit has a positive and negative wire.
Thank you very much for your attention
P.s. It is an airmar unit designed for ultrasonic imaging (sonar)