Although I have a lot of experience in stepper servo's used in floppy and hard disk drives, when I think of the overall requirements for readability , reliability and averaging, bounce, I think an analog display would be best for all conditions using the most accurate tilt sensor you have.Background:
One such device is to show when pallet forks attached to the front-end loader are level. I used an accelerometer to measure level and a GLCD for display. The prototype "worked" but had two major deficiencies: 1) The display was hard to read in all lighting conditions; and 2) "Bounce" made the reading too variable for its intended purpose.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?