Ravelstaff
New Member
The schematics and PC board design for the DIY project I am thinking about trying out is described in the PDF document at:
http://www.geocities.com/scubadiver_roli/download/acwif3.pdf
The (3) connector probes on the author's component list is from the German company Igun.
I am looking for an low cost, commonly available equivalent to Ingun's test probe (part #: 112 313 100 R 1502) in Orange County, California.
Does anybody know of something I could use in stead of the Ingun parts to do the same here? I'd like the contact probes to be spring loaded to ensure good contact with the dive computer terminals.
Any advice would be appreciated.
Thanks.
http://www.geocities.com/scubadiver_roli/download/acwif3.pdf
The (3) connector probes on the author's component list is from the German company Igun.
I am looking for an low cost, commonly available equivalent to Ingun's test probe (part #: 112 313 100 R 1502) in Orange County, California.
Does anybody know of something I could use in stead of the Ingun parts to do the same here? I'd like the contact probes to be spring loaded to ensure good contact with the dive computer terminals.
Any advice would be appreciated.
Thanks.