Fuel sender 0-5v help

MikeMl said:

What I posted is a schematic. You are asking for a pictorial diagram which shows physical parts. I dont have time for that.

You can do it. Start by printing out the data sheet for a LM358 op amp. It will show you pin numbers, etc. Get a piece of perf. board. Make a xerox of the bare board. Start placing components such as to minimize wire lengths.....

Click to expand...

stealthprobe said:

I plan on building pretty much the same thing. My fuel level sending unit outputs the same range of resistance. I have one question... will any op amp work? I found a NTE975SM at radio shack...

Click to expand...

stealthprobe said:

The ecu has a regulated 5v output. There is a Adc circuit on the ecu that accepts 0 - 5v. However i dont need to have it exactly from 0 to 5... i can have it from say... 1.5 to 4 volts and just scale the gauge in the software to match. whats important is that its linear.

Click to expand...