How to reset TSM110CN TRIPLE VOLTAGE AND CURRENT SUPERVISOR IC???

[aquamon]

Hi,

Just posted in wrong section I think.

I have an ATX PS for repair for a friend and not enough time to order a new one.

The 3.3V line was shorted by badly seated memory (after driving down a bumpy road).

Per attachment it says that the chip has to be reset after a fault sense but I can't figure out how to do this.

Pg. 10 Note :
Once the fault condition is removed, it is required to reset the
Remote pin to make the system function again.

 

[blueroomelectronics]

It should reset simply by unplugging it for a bit. Sounds more like something is damaged.

 

[aquamon]

yah,

i think you are right...

i have a 1v sine wave on pin 6 in sb. 0v when "on".
17v is at 20v and no pwm from i.c.

 

[mneary]

I have answered in your other thread.