Here is the board. Very simple with a microcrontrller. You will need to download Eagle CAD. I will look for the software and send the source and HEX. It uses a newer PIC so that is a good thing. You will need to get a PIC and program it. No promises, but if I find the code and after I see a picture of your board made, I will (for a small fee; chip and shipping) dig out a programmer and burn a chip for you if you can not get a programmer or someone to burn one for you. If nothing else this will give you a head start on the project. We had a blast with it, I played the host to the kids and wife. I just did a board for a fellow in another thread, since I had not done a board in some time. Just to keep the homemade skills up.