Rodrigo_trad
New Member
Hi everyone, new to this place.
So long story short, I used to have an aerial photography business using drones a few years back, one of them fell and broke and it was a beast; it was an octocopter with a 1.2 mts span (about 5ft I think) and I think it could lift upto 10kg but obviously never tried it.
So anyway the crash wasn't that bad but the body broke so I removed the motors and ESCs and stored them.
Now I feel like doing something with them other than flying, they are T-Motor Navigator series MN4014-9 KV400 that use a 40A ESC. and I have 10 or 12 I think. They are pretty much new, probably less than 100 hours flight time.
I've been searching for DIY ideas for these motor but I don't seem to find anything.
I have a shop at home where I make furniture and things like that on wood and metal, so making something along those lines maybe? I also have a 3d printer so that broadens the horizons a bit I think.
So if you think of something usefull or fun to do I'd appreciate it vey much!
So long story short, I used to have an aerial photography business using drones a few years back, one of them fell and broke and it was a beast; it was an octocopter with a 1.2 mts span (about 5ft I think) and I think it could lift upto 10kg but obviously never tried it.
So anyway the crash wasn't that bad but the body broke so I removed the motors and ESCs and stored them.
Now I feel like doing something with them other than flying, they are T-Motor Navigator series MN4014-9 KV400 that use a 40A ESC. and I have 10 or 12 I think. They are pretty much new, probably less than 100 hours flight time.
I've been searching for DIY ideas for these motor but I don't seem to find anything.
I have a shop at home where I make furniture and things like that on wood and metal, so making something along those lines maybe? I also have a 3d printer so that broadens the horizons a bit I think.
So if you think of something usefull or fun to do I'd appreciate it vey much!