Hey all, So I just purchased a motorcycle this month and I am now in the process of rewiring the previous owners 'electrical tape job' of doing is own flush mount turn signals. He went the cheap route and instead of buying some quality flush mounts that fit in the original slots of the old signals, he purchased some off of ebay that would seem to fit any model. I am not worried about the perfect look of the fitting and I kinda like the look of the flush mounts that he put on there, even it they are china made.
I tried to find the same signals he purchased on ebay and came to something that looked very similar but not exactly the same as there is no engraving on the signals on my fairings. My signals:
**broken link removed**
Ebay semi-equivalent: **broken link removed**
The signals are LED instead of lamps so an additional component is in the wiring. There is one power resistor per side of the the bike, one for the left circuit and one for the right.
This is a picture of the power resistors:
**broken link removed**
So they are 25 Watt, 6.8 Ohm resistors.
I plan on attaching both of the power resistors to a small aluminum plate to help dissipate the heat like so.
**broken link removed**
Here is a quick thrown together schematic of the setup when I received the bike.
**broken link removed**
I would like to make the turn signals brighter, to do so I was wondering if I can just replace the power resistors with new power resistors with a smaller watt rating or a smaller resistance value. I am not really sure on the exact behavior of these power resistors or how that change would affect the circuit.
edit: fixed initial gaffe