Serioxsinho
New Member
Hi, my mouse clicks were faulting a lot, since I had a spare one, I decided to buy new switches/clickers and replace it.
First time desolding things and didn't know that for solder through hole you need to add solder to make it easier. So I asume I put to much heat forcing the tip inside the hole and mesed up.
Right click works fine after replacement, left click doens't work at all even if I tried to jumper it.
I removed the component for the pictures.
I would like to know if there's something I can test/do to revive it since in my country the prices are skyrocketing from elections+inflation and is a $5 vs $150 solution.
First time desolding things and didn't know that for solder through hole you need to add solder to make it easier. So I asume I put to much heat forcing the tip inside the hole and mesed up.
Right click works fine after replacement, left click doens't work at all even if I tried to jumper it.
I removed the component for the pictures.
I would like to know if there's something I can test/do to revive it since in my country the prices are skyrocketing from elections+inflation and is a $5 vs $150 solution.