Junebug Tutor PCB

Wond3rboy

Member

• Jan 24, 2009

• #1

Hi i have been working on the Junebug Tutor PCB after making my Junebug. I have banged my self up in a corner.I have got six airwires left and no way of routing them.I know this is a poorly designed PCB but can any one tell me where i have gone wrong?I have used a switch for the IR sensor( i was to lazy to make one).I will add a capacitor that is left at the end.

 

Attachments

• Tutor.pdf

  24 KB · Views: 237

Last edited: Jan 24, 2009

Mikebits

Well-Known Member

• Jan 24, 2009

• #2

Why not just make pads for jumpers on top side. Single sided boards often need jumpers.

 

Wond3rboy

Member

• Jan 24, 2009

• #3

K. Thanks.i will do it.How would you rate my PCB work c,d? just to know how much i need to work at it?Very much obliged!

 

Mikebits

Well-Known Member

• Jan 24, 2009

• #4

I think you did very well. Maybe parts are spread out a bit, but good job overall

 

P

Pommie

Well-Known Member

Most Helpful Member

• Jan 24, 2009

• #5

Because this board isn't permanently connected to the Junebug there is no need for dip switches 1 to 3. That should simplify the layout slightly.

Mike.

 

Wond3rboy

Member

• Jan 24, 2009

• #6

Thanks Mike's i will eliminate them.