I was attempting to connect up my very first lcd last night, i got the connected to the board, and loaded the code, and all the lcd show are 2 lines of solid blocks, i checked the code over and i cant seem to find the problem. I attached the code, is there something in it that im missing,
its coded in swordfish se
The led i have on the board is blinking so i know the processor is doing something.
Well, I don't know that BASIC or how its libraries work, but two lines of solid blocks says to me that the LCD hasn't been initialized. 44780 LCD's do that when the power is turned on but they haven't been initialized.
i adjusted the contrast to that the line went away, im running the contrast pin thougth a 10 k pot as its all i have, this part seems to be working ok.
I was looking at my code agian, could the pic be geing stuck in my first while loop, and just ignoring the rest of the code?
I was loosely following the tutorial for spency's pic basic, the code was basically the same, i adjusted the clock, and option statements to meet my pin out and pic
you can compile the code for 16F and run the hex trough https://www.oshonsoft.com/ pic simulator (it simulates the LCD also) ..
as from the source code ..
Code:
...
While True
LED = 1 // Turn on the LED
DelayMS(500) // Delay for half a second
LED = 0 // Turn off the LED
DelayMS(500) // Delay for half a second
Wend
...
this loop will run forever, you never exit it .. you might use some for loop to do the blink some number of times, or some counter inside the loop then break the loop or goto from it ..
so in short, as your code is written, the DelayMS(150) will never be reached.
It should. Lcd libraries often ask for some LcdInit() before you start using the lcd, but i'm not familiar with compiler you are using, so you will have to try.
I was attempting to connect up my very first lcd last night, i got the connected to the board, and loaded the code, and all the lcd show are 2 lines of solid blocks, i checked the code over and i cant seem to find the problem. I attached the code, is there something in it that im missing,
its coded in swordfish se
The led i have on the board is blinking so i know the processor is doing something.
I was attempting to connect up my very first lcd last night, i got the connected to the board, and loaded the code, and all the lcd show are 2 lines of solid blocks,
with some slight tinkering to the wiring and the removal of the led flashing code, i got the data being displayed, just in case i ran out and bought a new pot to adjust my contrast
and everything is working perfectly now.
now i need to figure out how to have the chip multi tasking while displaying my infromation
Real time interupts are good for multi-tasking. Remember that there are certain timing requirements that need to be met when sending commands to the LCD module. There is a huge amount of info on this on the 'net.