Hello
Attached is the hardware schematic for the part in discussion.
Should this work between a 3v MCU and 5v SN75176?
I am testing between 2 boards (master and slave).When i cross Rx and Tx directly,my communication works.
When i add the attached ckt i cannot communicate between the 2.
This sounds crude on my part.But someone point out anything amiss and then i will explain more on what i debugged
Thanks and regards
Attached is the hardware schematic for the part in discussion.
Should this work between a 3v MCU and 5v SN75176?
I am testing between 2 boards (master and slave).When i cross Rx and Tx directly,my communication works.
When i add the attached ckt i cannot communicate between the 2.
This sounds crude on my part.But someone point out anything amiss and then i will explain more on what i debugged
Thanks and regards