If you want to, you can even store the data from the input until you want to read it later. You would use two 8 bit latchs with tri state outputs. You would connect the 8 inputs together and use the enable pins as your select bits. Bit 0 would enable latch 1, and bit 1 would enable latch 2, so that with both bits both outputs would be enabled. This of course is not a single device but two packages, but the circuit board routing is probably easier as you can spread the packages out a little more than with a single chip. The only extra routing complexity is that you have to wire the input lines together so that input bit 0 connects to input bit 0 on both packages, and same with bits 1 through 7.