Gday all,
I'm seeking some assistance with a small project I have, I'm fairly experienced in electronic's however my design experience is very limited.
I currently have my main HT reciever which has zones out connected to a remote power amp to drive speakers for different rooms for playing Music.
I have set up my main amp that when i switch on Zone 4 in this case, this will use one of the recievers triggered outputs on, which is 12V dc perminately high.
What i need for the secondary amp is a relay/switch circuit for a momentary short across the power switch, this i have achieved and works fine.
However why i'm here is I would also like it to momentarily short the power switch, thus turning seconday amp off (stby) when the 12V trigger is removed. (ie. turn zone 4 off on main amp)
Any suggestions/advice would be greatly apprieciated.
Regards
Rustyone
I'm seeking some assistance with a small project I have, I'm fairly experienced in electronic's however my design experience is very limited.
I currently have my main HT reciever which has zones out connected to a remote power amp to drive speakers for different rooms for playing Music.
I have set up my main amp that when i switch on Zone 4 in this case, this will use one of the recievers triggered outputs on, which is 12V dc perminately high.
What i need for the secondary amp is a relay/switch circuit for a momentary short across the power switch, this i have achieved and works fine.
However why i'm here is I would also like it to momentarily short the power switch, thus turning seconday amp off (stby) when the 12V trigger is removed. (ie. turn zone 4 off on main amp)
Any suggestions/advice would be greatly apprieciated.
Regards
Rustyone
Last edited: