Ok so I found this circuit and built it and it works right. But the thing is it keep repeating the timing over and over which drains the battery after awhile.
How can I change it so after one or two times timing. Can someone help me with that?
What do you mean by "it keeps repeating the timing over and over"? This circuit will turn on the buzzer after a predetermined time, and continue to buzz until you turn it off. When you turn it on again, the process will repeat. If it's behaving in any other way, you've made some mistake when you built it.
The circuit is not a timer. It is an oscillator that turns on the green LED then turns on the red LED then turns on the green LED again then turns on the red LED again over and over.
You could add a counter IC to count how many times it oscillates then the output of the counter turns on the reset pin of the 555 to stop it.
I might be wrong, because I only breifly looked, maybe someone can confirm this: The description of operation doesn't seem to match my understanding of the circuit design published.
It looks like pin 7 is connected when it isn't meant to be, if it's what I think it is, the circuit will auto-repeat, contrary to the description. If that's the case, then just cutting pin 7.
Pin 7 is connected exactly as in the monostable mods diagram of the As pin 2 is held high by the 33k resistor, I don't think pin 7 makes any difference. Connect it or not, IMO, the operation isn't affected.
EDIT: According to my simulation, pin 7 makes no difference at all. It can be connected or not. However, if the power is to be cycled quickly or often, leave it connected. NOTE: for those who read my earlier edit ( now deleated ) I had made an error in simulation and got a erronious result.
Yes that's right, of course. The 555 won't retrigger until pin 2 is dropped again. It only drops the once when power first applied.
Connected pin is 7 better, since it ensures that the next time period starts with a freshly discharged 200 uF (current-limited to sink current of pin 7). I guess that's why it's called 'discharge'
**broken link removed**
You power it up, green LED on, time period......
Then beep + red LED. It stays this way, until it's turned off or battery runs flat.
If it's re-triggering, it's most probably something to do with pin 2, maybe the track not cut properly.
So to make it only go one i just cut what copper tracks? because its just on a proto board not a pcb? And if that wont work which counter ic would you recomend?
If AG says a shortcircuit between pins 2 and 7 would cause your circuit to continually re-trigger, then I am saying look between pins 2 and 7 of your circuit, and see if there's a slither of copper track you haven't removed fully. Geez!
I think the circuit might be working properly and the OP just hasnt understood how it operates. In his first post, he siad the circuit continues to cycle after the original time out. Why is the circuit still operating after the timer has activated the buzzer? The circuit should be turned off untill it's needed again. If he's truning it off, then back on, it will continue to cycle. That's how it's supposed to work.
I know thats how its supposed to work but it keeps cycling ill just try to find out whats wrong with it. Im going to make a pcb for it anyway in a little so maybe rebuilding it will fix it