Orcad Layout to Corel Draw

[premkumar9]

Hi,
Can anybody please tell me how single sided PCB layout prepared using Orcad can be transferred to Corel DRAW.

 

[dknguyen]

Try using the gerber tool.

 

[premkumar9]

I think there is no problem in pulling down the O/P pin of 89C2051 to ground through a push switch (as it has a built in pull up resistor at this point which will limit the current). Am I right?

 

[premkumar9]

I think there is no problem in pulling down the O/P pin of 89C2051 to ground through a push switch (as it has a built in pull up resistor at this point which will limit the current). Am I right?

I mean as the microcontroller has a pull up resistor.

 

[universal1]

you can make this by creating gerber file from orcad then use gbr to bmp program to give you the bmp file then you can take it by corel

 

[premkumar9]

you can make this by creating gerber file from orcad then use gbr to bmp program to give you the bmp file then you can take it by corel

I did it by making prn file which I could open in Corel.

 

[duffy]

With the internal pull-up resistors the switch should not be a problem.