PCB photoresist method fail

Status
Not open for further replies.

MacIntoshCZ

Active Member
Hello everyone,
I am failing to get decent quality pcb. Biggest problem is that foil is not removed correctly. As you can see in image there are spots where you can see cuprexit layer, but honestly that was done by my finger. I am using negative photoresist film. Its old one and its really blue even before UV light exposure. I dont know what can cause this. Any ideas?
 

Presumably, and fairly obviously, it's long out of date?.
 
This last photo looks like it worked perfectly - you just need to put it back in ferric chloride etch solution for another few minutes. It will look great after that.
 
gophert said:
This last photo looks like it worked perfectly - you just need to put it back in ferric chloride etch solution for another few minutes. It will look great after that.
Click to expand...
It tooks around 30mins to etch in hcl + peroxide.
 
Last edited:
I use Amonium persulphate for etching but gave up making my own about 8 years ago. When I did make them I found that edge burrs can stop things working properly.

Mike.
 
MacIntoshCZ said:
It tooks around 30mins to etch in hcl + peroxide.
Click to expand...

That's pretty typical for 1oz copper if you are not agitating it. It tends to go faster if you put the board copper-side down and slowly move the dish. Also, if the copper stops dissolving, it means you've run out of active peroxide in your mix. Peroxide is an unstable material and is constantly decomposing - even in the bottle. So, you can assume the concentration is lower than the label says.
 
Status
Not open for further replies.

Similar threads

F
PCB ---> Mahjong Skills?
Replies
1
Views
467
For The Popcorn
F
  • Question
Cheap PCB's from JLC PCB, including cheap postage.
2
Replies
32
Views
2K
MrAl
M
N
  • Question
Toaster PCB Repair
Replies
4
Views
3K
Les Jones
L
  • Question
pcb malfunction
2
Replies
39
Views
6K
rjenkinsgb
  • Solved
pcb board recover help
2
Replies
28
Views
3K
baristini
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…