PIC enable.....AP6714 Boost Converter

Hello

I'm doing an experiment with a 3.3V PIC18F67k22. Everything is working fine and all i want for my next stage development is to enable disable a boost converter 'AP6714' via its enable/disable pin from a command comming from the PIC. From the datasheet link below, i know how to connect
etc. all i'm concerned is what value should i use for Rtop and Rbottm to get a 5V output. So my PIC will enable the boost converter with 3.3V and then I will want 5V output.

Boost Converter datasheet.....
https://www.electro-tech-online.com/custompdfs/2012/03/AP6714.pdf

Can anyone suggest the values for Rtop and Rbottom?

Haseeb

The enable input of the boost convert will go high at .8volts no conversion is required.