I'm a little confused as to what resistor I need to use for the reset pin on my AVR.
The datasheet for my AVR says minimum 30K however the programmer ( Avrisp MK2) says it should be no higher than 4.7K otherwise it detects it as a short which is what happened when I put a 10K resistor in. My supply voltage is 5V.
from the datasheet for my avr chip
0.1Volts is the maxiumum voltage it will register as logical low.
VCC + 0.5V is registered as logical high.
Also may I ask if an ouput pin is turned logical low, does that mean it will sink current?